If you climb to the top of Mt. Everest, you will be 8850 m (about 5.50 mi) above sea level.
What is the acceleration due to gravity at this altitude?

Answer:

C. Forebrain

Explanation:

The Basil Ganglia, sits on the base of the forebrain.

the wave has a speed of 12 m/s.

Explanation:

Speed is directly proportional to wavelength and frequency. The wave has a frequency of 4 Hz. One Hertz (Hz) is equal to one cycle per second. The image shows that the wave has a wavelength of 3 m. Using the given speed and frequency, the wavelength can be calculated as shown below.

speed= wave length x frequency

speed = 3m x 4Hz

speed = 12m m/6

Answer:

7 m/s²

Explanation:

F= ma

A= F/m = 42/6 = 7 m/s²

D. So the scientists can repeat the same experiment and get the same or similar results.

Answer:

C

Explanation:

Answer:

to find the displacement, or delta x (change in position) on a velocity graph, you can find the area under the line on the graph: between 1 and 8 seconds, the dog was going at 5m/s, so 5m/s x 8s=40m, for the second part, you have to find the area of both a triangle and a rectangle, so the rectangle would be 5m/s x 5s=25m and the area under the triangle would be (5m/s x 5s)/2=25m/2=12.5m -you divide by 2 because it's a triangle

-afterwards, you would add the area of the 2 sections together, so 40m+25m+12.5m=77.5m

Explanation:

Answer:

(B). Liquid sodium or water

Explanation:

I don't know how to explain this But hope it right!

If I'm wrong I'm sorry

If I'm right Thank you and (brainliest plz)

===============================================================

Explanation:

We'll need the acceleration first.

The acceleration is equal to the change in speed over change in time

a = acceleration

a = (change in speed)/(change in time)

a = (Vf - Vi)/(4 seconds)

a = (0 - 8.0)/4

a = -8/4

a = -2

The acceleration is -2 m/s^2, meaning that Sam slows down by 2 m/s every second. Negative accelerations are often associated with slowing down. The term "deceleration" can be used here.

Here's a further break down of Sam's speeds at the four points of interest

Next, we'll apply Newton's Second Law of motion

F = m*a

where,

We just found the acceleration, and the mass is fairly easy as all we need to do is add Sam's mass with the sled's mass to get 60+5.0 = 65 kg

So the force applied must be:

F = m*a

F = 65*(-2)

F = -130 newtons

This force is negative to indicate it's pushing against the sled's momentum to slow Sam down.

The magnitude of this force is |F| = |-130| = 130 newtons

Answer:

yes

yes yes yes yes

yes yes yes

Answer: The Sun measures 1.4 million km across, while the Moon is a mere 3,474 km across. In other words, the Sun is roughly 400 times larger than the Moon. But the Sun also happens to be 400 times further away than the Moon, and this has created an amazing coincidence.

Explanation:

Answer:

answer is option (c) child labour

Answer:

the applied force is greater than the force of friction

Explanation:

pls give brainliest it makes me feel smart

Answer:

hi!

Explanation:

The answer is option b.

A box can definitely not move on it's own unless an external force is applied i.e muscular force. If the applied force would have been less than the force of friction then the box would have never displaced. But, since the box is able to move, we can imply that, the applied force is greater than the frictonal force leading in the displacement of the box.

Answer:

Conservation

Explanation:

Answer:

1. Kinetic energy is the energy possessed by a body due to its motion. Potential energy is the energy possessed by a body due to its position or state. Kinetic energy can be transferred from one object to another, in case of collisions. Potential energy cannot be transferred. Thus, the potential energy is stored in the object due to its position, whereas the kinetic energy is possessed by an object due to motion.

Eg: A ball kept on the edge of the table possesses potential energy due to its height, whereas a ball falling down from the table will possess kinetic energy due to its motion.

2. The formula for Kinetic energy is as below: This means that kinetic energy is directly proportional to mass as well as velocity. But it is proportional to 1 unit of mass and a square of velocity. Hence, velocity has a greater effect on kinetic energy.…show more content…

3. The equation for kinetic energy is: .

Let’s calculate the kinetic energy of a 40 kg object traveling 15 m/s.

Solution: mass= 40kg, velocity= 15 m/s, so putting these numbers into the kinetic energy equation,

Now, let’s calculate the kinetic energy of a 40 kg object traveling 30 m/s.

Solution: mass= 40kg, velocity= 30 m/s, so putting these numbers into the kinetic energy equation, Thus, when we double the velocity of an object, its kinetic energy increases by four times. Hence the velocity of an object has more impact on kinetic energy than the mass of an object.

Explanation:

Answer:

10880N

Explanation:

We are given that

Mass of elevator, m=850 kg

Acceleration, [tex]a=3m/s^2[/tex]

[tex]g=9.8m/s^2[/tex]

We have to find the tension in the cable.

We know that

When elevator is accelerating upward then tension in the cable

[tex]T=m(a+g)[/tex]

Using the formula

[tex]T=850(3+9.8)[/tex]

[tex]T=10880N[/tex]

Answer:

Mercury

Explanation:

Answer:

unequal

Explanation:

White light is a combination of all colors in the color spectrum.

Answer: C) equal

If you use a glass prism, you can split white light into a rainbow which shows all of the colors along a spectrum. Each little color slice is the same width. In other words, something like green doesn't dominate the spectrum and take up a wider portion compared to other colors.

Answer:

x=7

Explanation:

2x+1-2x=8

or,2x-2x=8-1

x=7

Answer:

Shadow

Explanation:

Shadow is a area of darkness.

When sunlight falls on an object ot blocks the light from getting onto the surface . Hence, as light does not falls on that region it is dark. Hence, the shadow is the area of darkness.

Answer:

shadow is a area of darkness

It's Acceleration

We can calculate the average speed by finding the total distance traveled divided by the elapsed time: Average speed=–s=Total distanceElapsed time. Average speed = s – = Total distance Elapsed time.

Answer:

D. When a chemical reaction releases energy, it is an example of an endothermic reaction.

Explanation:

"Endo" means within. Therefore, an endothermic reaction releasing energy makes no sense.

p.s.

I owe you for your help.

Thank you so much!

The statement that is not true about the chemical reaction is when a chemical reaction releases energy, it is an example of an endothermic reaction, therefore the correct answer is option D.

A chemical reaction is a process in which one or more substances, also known as reactants are converted to one or more different substances, known as products.

A chemical reaction rearranges the constituent atoms of the reactants to create different substances as products.

Substances with novel characteristics are created through chemical reactions.

Products of chemical reactions differ from the reactants in terms of their features.

Chemical bonds may break or produce new ones during interactions.

The excess energy is released during an exothermic reaction, making the potential energy of the reactant higher than the potential energy of the product. The right response is D.

To learn more about chemical reactions, refer to the link;

brainly.com/question/22817140

#SPJ2

Answer:

you want to know newtons first law here.

Explanation:

An object that is at rest stays at rest or stays in motion.

Answer:A

Explanation:

It’s bigger I am not sure

Answer:

For the first question, the answer is

B. Kettle

Answer:

* Temperature changes

* Changes in the tension

* Errors in the meter marks

Explanation:

When we are using several meters to make a measurement we have several aspects that can cause the readings to differ.

* Temperature changes make the dilation between readings different, at higher temperatures the material of the meter expands and the reading decreases.

* Changes in the tension with which the meter is pulled to keep it straight, in general all materials bend under the action of gravity, so you have to pull them to make them straight, if the forces are different from the material is lengthened decide Young's modulus, inducing different readings

* Errors in the meter marks, especially in the initial part that is covered by a hook, different positions of the hook change the readings.

* Structural problems, such as rust, bends that create changes in the length of the meter material.

Answer:

The dependent variable is the variable being tested and measured in an experiment, and is 'dependent' on the independent variable. An example of a dependent variable is depression symptoms, which depends on the independent variable

Explanation:

I HOPE FOR A GOOD RESPONSE

HAVE A NICE DAY

Answer: Momentum can be defined as "mass in motion

Explanation:

Answer:

Plate tectonics is a scientific theory describing the large-scale motion of seven large plates and the movements of a larger number of smaller plates of Earth's lithosphere, since tectonic processes began on Earth between 3.3 and 3.5 billion years ago