Answer:
1) C, 2) C, 3) B, 4) D, 5) A/B, 6) D, 7) D, 8) A, 9) B, 10) A
Explanation:
1) Seconds, minutes and days are time units. (Correct answer: C)
2) The displacement is shortest distance between the point of origin and the point of destination. (Correct answer: C)
3) The velocity is the rate of change of position in time. (Correct answer: B)
4) Graphs are a very useful ressource to infer characteristics inherent to a studied physical variable. (Correct answer: D)
5) There are two possible answers, since both milimeters and meters are units for distance. (Correct answers: A/B)
6) The distance is the arc length of the entire path that object travelled. (Answer: D)
7) Traditionally, in a position vs. time graph we plot time in the x-axis. (Answer: D)
8) In this case, we use a distance-time graph, where travelled distance is the dependent variable and time is the independent variable. (Answer: A)
9) The point of origin is the initial position of the object. (Answer: B)
10) The point of destination is the final position of the object. (Answer: A)
Which choice is the BEST source of PROTEIN?
1 Meat
2 Bread
3 Rice
4 Apples
Answer: It's 1 meat.
Explanation: Meat is a protein, bread and rice are grains, Apples are fruit!
Your welcome
A 8.0-g bullet with an initial velocity of 115.0 m/s lodges in a block of wood and comes to rest at a
distance of 4.0 cm. Assume the bullet undergoes a constant negative acceleration; it slows at a
constant rate.
a. How much time does it take for the bullet to stop?
b. What is the impulse on the woodblock?
c. What is the average force experienced by the block?
In the analogy for how a wave travels along a line of dominoes standing on end, each domino represents___________.
Answer:
im 99% sure its initial disturbance
Explanation:
definition of mass number
Answer:
The total number of protons and neutrons in a nucleus.
Explanation:
I memorized it.
Answer:
Mass number of an atom is defined as the sum of the number of protons and number of neutrons.
A book is resting on the floor. It has 25 J of energy. A student lifts the book and places it on the top shelf of a bookshelf. The student uses 200 J of energy to lift the book onto the shelf. How much energy does the book have at the top of the shelf?
A.Exactly 25 J
B. About 225 J
C. At least250 J
D.Negative 175 J PLSS QUICK (3 minutes at most) ILL GIVE 70 POINTS AND BRAINLIEST (FOR CORRECT ANSWER)
Answer and Explanation:
A. Exactly 25 J.
This is because the 25 J of energy that is holding down the book will always be the same, unless another force is being applied to hit to either make it heaver for a combined force of J energy, or something is lifting it, which will subtract the force of J of energy whilst moving.
#teamtrees #PAW (Plant And Water)
What effect does the Sun have on the ocean tides?
A.
The Sun does not have an effect on the ocean tides because it is
too far away.
B. The Sun warms the water, causing it to rise.
C. The gravitational pull of the Sun causes spring and neap tides.
D.the gravitational pull of the sun gravity is more powerful then the moons
Answer:
B
Explanation:
When the sun, moon, and Earth are in alignment at the time of the new or full moon, the solar tide has an additive effect on the lunar tide, creating extra-high high tides, and very low, low tides both commonly called spring tides.
Electric cables for your lamp have a plastic rubber coating around the wire. Explain why this material surrounds the metal cable.
This is 100 points
Answer:
theyre used to prevent accidental contact with other conductors of electricity, which might result in an unintentional electric current through those other conductors.
Explanation:
Metal cables are conductor of electricity but plastic rubber coating is insulator and can not conduct current. To avoid unnecessary flow of current and safely current transmission, this material surrounds the metal cable.
What are conductor and insulator?Materials that easily permit the flow of electricity are referred to be electrical conductors. Conductivity is the quality of conductors that enables them to conduct electricity.
Insulators are substances that prevent electrons from freely moving from one elemental particle to another. The charge stays in the same spot and does not spread across the surface if we transfer any quantity of charge to such an element at any time.
Copper, aluminum, gold, and silver are a few examples of common conductors. Wood, rubber, plastic, and glass are a few typical insulators.
Learn more about insulator here:
https://brainly.com/question/2619275
#SPJ2
How much force is required to move a electron through an electric field with strength of 1.375 x 10^19 N/C?
Answer:
The magnitude of the force required to move the electron through the given field is 2.203 N
Explanation:
Given;
The field strength of the electron, E = 1.375 x 10¹⁹ N/C
charge of electron, q = 1.602 x 10⁻¹⁹ C
The magnitude of the force required to move the electron through the given field is calculated as follows;
F = Eq
F = (1.375 x 10¹⁹ N/C) (1.602 x 10⁻¹⁹ C)
F = 2.203 N
Therefore, the magnitude of the force required to move the electron through the given field is 2.203 N
When serving you start on the right and must hit to which designated area?
- right side you are looking at
- left side you are looking
- any place over the net
(pickle ball)
you can serve to anyplace over the net
use the following terms in the same sentence magnet magnetic force and magnetic pole
Answer:
The electrically charged gas particles are affected by magnetic forces.
For the past eleven years, the Sun's north geographic pole has also been home to its north magnetic pole
Explanation:
Un coche inicia un viaje de 450 km a las ocho de la mañana con una velocidad media de 90 km/h. ¿A qué hora llegará a su destino?
Answer:
Llegara a su destino a la 1:00 pm
Explanation:
Si el coche va a 90 km/h buscamos un numero q al multiplicarlo por 90 nos de 450. Entonces 90×5 = 450, si hacemos la cuenta desde las ocho de la mañana mas las 5 horas del viaje terminaria llegando a su destino a la 1:00 pm.
4. An automobile gasoline engine is able to do 225 J of useful work with each stroke of its
pistons. If the engine has an efficiency of 29%, what is the amount of work that must be done on
the pistons in the engine?
[tex]\mathfrak{\huge{\orange{\underline{\underline{AnSwEr:-}}}}}[/tex]
Actually Welcome to the concept of Efficiency.
We know that, efficiency is given as,
E (eta) = Output work / Input Work
hence, here, E = 29% and Output work = 225
hence, 29% = 29/100 in real..
hence, the work done on piston is given as,
29/100 = 225/I
therefore, I = 225*100/29 ==> I = 22500/29 ==> I = 775.8 joules
hence, the work done on the pistons is 775 J
Which choice Not a direct risk of eating a diet too high in sugar? 1 diabetes 2 weight gain 3 tooth decay 4 weight loss
Answer:
4 weight loss
Explanation:
If you are in a car that stops suddenly, what does your body continue to do?
Answer:
If the passengers were not wearing their seat belts:, then the passengers in motion would continue in motion. Assuming a negligible amount of friction between the passengers and the seats, the passengers would likely be propelled from the car and be hurled into the air. Once they leave the car, the passengers becomes projectiles and continue in projectile-like motion.
If they were: Any passengers in the car will also be decelerated to rest if they are strapped to the car by seat belts. Being strapped tightly to the car, the passengers share the same state of motion as the car. As the car accelerates, the passengers accelerate with it; as the car decelerates, the passengers decelerate with it; and as the car maintains a constant speed, the passengers maintain a constant speed as well.
I got this from https://www.physicsclassroom.com
reason why ink is most likely to ooze out of a pen when one is up in an airplane
Answer:
Because in higher altitudes atmospheric pressure is low
5 examples of electrical energy
Answer:
its very simple this list the items that you have in your house that have electric energy
Explanation:
Planetesmals are made from
A planetesimal is an object formed from dust, rock, and other materials. According to the planetesimal hypothesis, when a planetary system is forming, there is a protoplanetary disk with materials from the nebulae from which the system came. This material is gradually pulled together by gravity to form small chunks.
Brainliest or a thank you please :)) <3
give the relation of speed of sound with the density and temperature
Answer:
The greater the density of a medium, the slower the speed of sound. This observation is analogous to the fact that the frequency of a simple harmonic motion is inversely proportional to m, the mass of the oscillating object.
Air molecules have more energy at higher temperatures, which means they vibrate faster. This allows the sound waves to also travel faster because they are propelled by collisions between the molecules
Michael is trying to move his desk from one from side of his room to the other. Unfortunately, the desk doesn't actually move. Considering the equation W=Fs, What has not been done by Michael ?
Answer:
Work hasn't been done by Michael because no distance was covered.
Explanation:
Workdone is given by the formula;
[tex] Workdone = F * s[/tex]
Where;
W is the work done
F represents the force acting on a body.
s represents the distance covered by the body.
Hence, work hasn't been done by Michael because no distance was covered, as the table didn't move at all. Therefore, work done is zero.
help meeeeeeeeeeee
what is the rheostat and what its ruleeee??
Answer:
Rheostat, adjustable resistor used in applications that require the adjustment of current or the varying of resistance in an electric circuit. The rheostat can adjust generator characteristics, dim lights, and start or control the speed of motors.
Explanation:
A book is placed on a table and a bike moves on a road.
Which statement is correct?
Both the book and the bike have kinetic energy.
Both the book and the bike have potential energy.
The book has potential energy and the bike has kinetic energy.
The book has kinetic energy and the bike has potential energy.
The book has potential energy and the bike has kinetic.
kinetic energy is energy possessed when a object is in motion. The bike is moving. Therefore, it has kinetic energy. The book isn't moving. Hopefully that helped
Give me two examples of a pushing force and two examples of a pulling force:
Answer:
A pushing force example could be a button, like on a keyboard.
Another example would be a piston.
An example of a pulling force could be a lever.
Another example could be rope.
Hope this helps! c:
HELP ME PLEASEeeeeèeeeee
9514 1404 393
Answer:
5) 0.64Ω
6) 0.16 W
Explanation:
Put the given numbers into the given formula and do the arithmetic.
5)
[tex]\text{ohms}=\dfrac{\text{volts}}{\text{amps}}=\dfrac{0.32\text{ V}}{0.50\text{ A}}=\boxed{0.64\ \Omega}}[/tex]
__
6)
[tex]\text{watts}=\text{volts}\times\text{amps}=(0.32\text{ V})\times(0.50\text{ A})=\boxed{0.16\text{ W}}[/tex]
Answer:
just ok02
#CARRYONLEARNING
what is conservation of energy in physics?
Answer:
https://www.khanacademy.org/science/physics/work-and-energy/work-and-energy-tutorial/a/what-is-conservation-of-energy
Explanation:
Look at this website it gives you all the details! :)
if u have 2500Watts,240Volts . its resistance
Answer:
2500/240 will give the resistance to be 10.42
The elements in which section of the periodic table are the most stable and rarely react with other elements?
А metals
B metalloids
С noble gases
D nonmetals
This is graded help hurry pls
how dose storing waste underground can be effected by ground water in aquifers
Answer:
it can contaminate the water
Explanation:
I hope this helps ;)
HELP THIS IS TIMED PLEASE OMG
Answer:
d) 40000 kgm/s
Explanation:
The formula for momentum is p = m*v
so p = 100*400
p = 40000 kgm/s
A king orders a gold crown having a mass of 0.5 kg. When it arrives from the metalsmith, the volume of the crown is found to be 185 cm3. Is the crown made of solid gold?
Answer:
The crown is not made of solid gold.
Explanation:
Density ρ = M/V. M and V are given.
The density of the crown is (0.5 kg)/(185 cm3) * (106 cm3)/(1 m3) = 2.7*103 kg/m3.