300,000,000 m/s is the speed of ?

Answer:

The equation for percent composition is (mass of element/molecular mass) x 100.

please mark me as a brainlist

LPG is composed hydrocarbons containing three or four carbon atoms. The normal components of LPG thus, are propane (C3H8) and butane (C4H10). Small concentrations of other hydrocarbons may also be present.

Answer:

It is often necessary to start campfire with many pieces of kindling rather than large logs because it is easier to ignite smaller pieces than larger pieces. Imagine wanting to light up a pile of clothes and a small piece of a shirt. Which ignites faster? The piece of a shirt, because it is smaller and more likely to burn very quickly. Additionally, people criss-cross these tiny pieces of wood to enable more surface area and to allow more oxygen to pass through. As you know, oxygen is necessary for a flame to ignite.

Answer:

4.52×10^24

Explanation:

N = n × Na

where; N = no. of bananas

n = no. of moles

Na = Avogadro's constant

Which is 6.02×10^23

N = 7.5 × 6.02×10^23

N =4.515×10^24

Answer:

Metals conduct electricity because they have free Electrons in them which helps the current to move eaisily

Answer:

58

Explanation:

Due to conservation of energy, the sum of the reactants = the sum of the products. So 28 + 30 = 58g

Answer:

0.316 moles are produced.

Explanation:

We state the redox reaction:

4HNO₃   + Cu   →  Cu(NO₃)₂ + 2NO₂ + 2H₂O

We need to determine the limting reactant:

0.1 L . 14 M = 1.4 moles

10 g . 1mol/ 63.54g =0.158 mol

Cu is the limiting reactant. Let's see

4 moles of acid need 1 mol of Cu to react

1.4 moles of acid may react to (4 . 1) / 1.4 = 0.35 moles

We do not have enough Cu.

1 mol of Cu can produce 1 mol of NO₂

Then 0.158 moles will produce, 0.316 moles. (double of moles)

If we see stoichiometry, ratio is 1:2

Answer:

the reaction is violent and quick

Explanation:

Answer:

c...................................

Answer:

When the solar winds approach the Earth, the magnetosphere (part of the Earth's natural magnetic defenses) deflects/repels most of the charged particles and shields our planet's surface from the winds. Sometimes, however, the magnetosphere isn't strong enough to block the Earth from these winds, so they do hit Earth and may cause catastrophic consequences, such as ruin power grids, cut off telecommunications (cell service/calls), etc.

Hope this helps you out! Have a nice day! :)

Answer:

8 .....................

Answer: A chemical symbol is a one- or two-letter designation of an element. Compounds are combinations of two or more elements. A chemical formula is an expression that shows the elements in a compound and the relative proportions of those elements. Many elements have symbols that derive from the Latin name for the element

Answer:

3SiO2  +  2CaC2 ------>   3Si  +   2CaO  +  2CO2

Explanation:

Answer:D

Explanation:

i got it right LOL

Among the given options, the one which is not a major function of musculoskeletal system is helping the lungs take in air. All others including, energy, digestion, movement of bones etc. are its function.

The musculoskeletal system in human body is composed of muscles and bones. The bones in our body are wrapped by the muscles. Muscles helps for the smooth movement of bones.

Muscles convert the chemical energy from food into kinetic energy and use  it for the movement of muscles and bones. Muscles contraction needs intake of energy.

The contraction and relaxation of smooth muscles helps for the easy movement of food through the digestive track. Musculoskeletal system also helps for the movement of other organ system. Hence, option b is not the major function of this organ system.

Find more on musculoskeletal system :

https://brainly.com/question/13837035

#SPJ6

Answer:

3.45 x 10^5

Explanation:

Answer:

43.76 g = 0.04376 Kg

Explanation:

The equation of the reaction is given as;

H2 + Cl2 --> 2HCl

From the equation;

1 mol of Cl2 produces 2 mol of HCl

Converting to mass;

Mass = Number of mol * Molar mass

Cl2;

Mass = 1 mol * 70.906 g/mol = 70.906 g

HCl;

Mass = 2 mol * 36.458 g/mol = 72.916 g

This means;

70.906 g of Cl2 produces 72.916 g of HCl

x g of Cl2 would produce 45g of HCl

70.906 = 72.916

x = 45

x = 45 * 70.906 / 72.916

x = 43.76g

Answer:

es correcto bro claro eres un crak

Answer:

Decomposition Reaction

Explanation:

You can determine the type of reaction by writing out a balanced equation.

Solid Potassium Chlorate: KClO3

Potassium Chloride: KCl

Oxygen Gas: O2

Balanced Equation: 2KClO3 -> 2KCl + 3O2

By definition, a decomposition reaction is when a single substance decomposes into two more simpler substances. AB -> A + B

Because the solid potassium chlorate is breaking into two substances, potassium chloride and oxygen gas, it is a decomposition reaction.

Answer:

it has 6?

Explanation:

The answer should be 6

whatm iş your name msmsjwjnsnwjq

Answer:

solid liquid and gas

Explanation:

ice is a solid then it melts to liquid and evaporates into gas

Answer:

Snow is basically water;

ice/snow is solid state

water is liquid state

vapour is gaseous state

Explanation:

Answer:

0.67atm is the new pressure of the gas

Explanation:

To find one condition of a gas when pressure, volume and absolute temperature change we must use combined gas law:

[tex]\frac{P_1V_1}{T_1} =\frac{P_2V_2}{T_2}[/tex]

Where P is pressure, V is volume and T is absolute temperature of 1, initial state and 2, final state of the gas.

Replacing:

P₁ = 1.12atm

V₁ = 156mL

T₁ = 28.1°C + 273.15K = 301.25K

P₂ = ?

V₂ = 312mL

T₂ = 87.2°C + 273.15 = 360.35K

1.12atm*156mL / 301.25K = P₂*312mL / 360.35K

P₂ = 0.67atm is the new pressure of the gas

Answer:

shear adhesion

Explanation:

edge

Shear adhesion sticks best when it is pulled down parallel to the surface.

Shear adhesion is defined as the ability  of tape due to which it resists the static forces which are applied in same plane as in backing.It is usually expressed in terms of time required  by a given weight for an amount of tape to become loose  from a vertical plane.

Molecular weight between two entanglements is the controlling factor of shear adhesion. Shear adhesion is affected by the following parameters which areas follows:

1)Tg of adhesive - Shear adhesion increases as Tg rises up to a certain temperature which is less than the room temperature.

2)  Tan delta  minimum value of adhesive- It is found that shear adhesion improves by an increase in tan delta minimum value.

3)Adhesive polarity- It is an important factor which affects adhesion  such as tack,peel and shear.Adhesion performances are improved by introducing polar ingredients in the formulation.

Learn more about shear adhesion,here:

https://brainly.com/question/13385447

#SPJ6

The carbon and silicon have in common that they belong to the same column (family), therefore they have the same number of total electrons. So, option B is correct.

Carbon's closest analogue is silicon. Silicon and carbon are both tetravalent atoms that primarily form covalent (non-ionic) compounds. However, aside from the fact that both elements "can form four covalent bonds," there is surprisingly little in common between them.

Carbon has an atomic number of 6 and an electronic configuration of 2, 4. Silicon has an atomic number of 14 and an electronic configuration of 2, 8, 4. Because both elements have the same number of valence electrons, they are classified as being in the same group.

Thus, option B is correct.

To learn more about the carbon and silicon, follow the link;

https://brainly.com/question/1966406

#SPJ1

Answer:

its the first part in mass of sodium

Explanation:

:)

Answer:

Atom, cell, dust particle, ant, ping pong ball

Explanation:

Firstly, atoms make up all matter, including each of the items on that list. The only things smaller than atoms are the parts of the atom itself, protons, neutrons and electrons. Because none of those are on that list, atoms have to be the smallest. Next smallest is the cell. Cells are made up of atoms, but they also in part make up dust. You can see a dust particle with the naked eye, but in order to see a cell you must use a microscope. Thus, cells are smaller than dust particles. Next is an ant. Obviously, an ant is bigger than a speck of dust, and is made up of cells and atoms. Lastly all you have is the ping pong ball, which is much larger than the rest of the items. Hope this helps!

All matter, including each thing on the list, is made up of atoms. The protons, neutrons, and electrons that make up an atom are the only particles smaller than atoms.

Thus,  Atoms must be the tiniest object because none of those are included in that list. The cell is the next smallest. Atoms make up cells, but dust also makes up a portion of them.

A dust particle can be seen with the unaided eye, but a microscope is required to see a cell.

Cells are hence smaller than dust particles. An ant comes next. Of course, an ant is composed of cells and atoms and is larger than a particle of dust.

Thus, All matter, including each thing on the list, is made up of atoms. The protons, neutrons, and electrons that make up an atom are the only particles smaller than atoms.

Learn more about Atoms, refer to the link:

https://brainly.com/question/1566330

#SPJ2

Answer:

the action of magnifying something or the process of being magnified

Answer:

1 : the act of magnifying. 2a : the state of being magnified. b : the apparent enlargement of an object by an optical instrument. — called also power

Answer:

This means that the pressure would become double of it's initial pressure.

Explanation:

Key statements:

- Constant temperature

- What happens to the pressure of the gas if the volume was

smooshed down to half its original size?

Basically the question is asking about the relationship between pressure and volume at constant temperature. This is given by Boyle's law.

Boyle's law states that the volume of a fixed mass of gas is inversely proportional to it's volume at a fixed temperature.

This is given by;

P1V1 = P2V2

Where;

P1 = Initial pressure

P2 = Final pressure

V1 = Initial Volume

V2 = Final Volume

From the question;

V2 = V1/2

Inserting it into the equation;

P1 V1 = P2 V1/2

Divide all through by  V1

P1  = P2 /2

P2 = 2 P1

This means that the pressure would become double of it's initial pressure.