1. The equation for the reaction between zinc and aqueous copper(II) sulfate is shown.

Zn + Cuso, → ZnSO, + Cu

Which statement is correct?

a. The oxidation state of the oxidising agent has changed from 0 to +2.

b. The oxidation state of the reducing agent has changed from 0 to +2.

c. The oxidation state of the reducing agent has changed from +2 to 0

d. This is not a redox reaction. The solution changes from colourless to blue.

Answer: D. All of the above describe a mole

Explanation:

Mole is the unit for amount of substance. It is used for describing large number of particles.

According to avogadro's law, 1 mole of every substance weighs equal to molecular mass and contains avogadro's number [tex]6.023\times 10^{23}[/tex] of particles.

For example: 1 mole of Na atom will weigh 23 grams and contains [tex]6.023\times 10^{23}[/tex] atoms.

Thus all the above describes a mole.

Answer:

[tex]V_{base}=24.04mL[/tex]

Explanation:

Hello!

In this case, according to the chemical reaction by which HBr reacts with Ba(OH)2:

[tex]2HBr+Ba(OH)_2\rightarrow BaBr_2+2H_2O[/tex]

We can see there is a 2:1 mole ratio between the acid and the base; thus, at the equivalent point we can write:

[tex]2M_{base}V_{base}=M_{acid}V_{acid}[/tex]

Therefore, for is to compute the volume of the used base, we proceed as shown below:

[tex]V_{base}=\frac{M_{acid}V_{acid}}{2M_{base}}[/tex]

And we plug in to obtain:

[tex]V_{base}=\frac{0.319M*50.8mL}{2*0.337M}\\\\V_{base}=24.04mL[/tex]

Best regards!

Answer: The formic acid is 3.5 times stronger than acetic acid.

Explanation:

The strength of an acid depends on its acid dissociation constant.

For a hypothetical monoprotic acid HA, the dissociation equilibrium is:

[tex]HA\rightleftharpoons H^++A^-[/tex]

[tex]K_a=\frac{[H^+][A^-]}{[HA]}[/tex]

More is the value of [tex]K_a[/tex] , greater is the dissociation and stronger is the acid.

[tex]\frac{Strength_{\text {formic acid}}}{Strength_{\text {acetic acid}}}=\sqrt{\frac{2.14\times 10^{-4}}{1.81\times 10^{-5}}}=3.5[/tex]

Thus formic acid is 3.5 times stronger than acetic acid.

Answer:

removal of H2O

✔ System will shift toward the products.

addition of O2      

✔ System will shift toward the products.

decrease in pressure

✔ System will shift toward the reactants.

increase in temperature      

✔ System will shift toward the reactants.

Explanation:

The reaction Equation :

2H₂ (g)  + O₂ (g) ↔ 2H₂O (g) + heat

Answer :

a) Removal of H₂O : The system will move towards the products of the reaction

b) addition of O₂ : The system will move towards the products of the reaction

c) decrease in pressure : The system will tend to move towards the reactants

d) Increase in temperature: The system will tend to move towards the reactants as well

Reason

In an equilibrium reaction changes to reactant components surroundings/conditions in which the reaction is been carried out can cause a significant change in the entire reaction process.

Hence; Removal of H₂O will cause the reaction system to move towards the products also the addition of O₂ will make the equation of the  reaction system move towards the product

Decrease in pressure and Increase in temperature causes the equation to move towards the reactants of the reaction

Learn more about equilibrium reaction : https://brainly.com/question/16878977

Answer:

1.6666666666666 is the ans bcz in each mole there r 12 grams of carbon so the ans is goingtobe 20÷12

According to the mole concept, there are 1.66 moles in 20 grams of carbon.

Mole is defined as the unit of amount of substance . It is the quantity measure of amount of substance of how many elementary particles are present in a given substance.

It is defined as exactly 6.022×10²³ elementary entities. The elementary entity can be a molecule, atom ion depending on the type of substance. Amount of elementary entities in a mole is called as Avogadro's number.

It is widely used in chemistry as a suitable way for expressing amounts of reactants and products.For the practical purposes, mass of one mole of compound in grams is approximately equal to mass of one molecule of compound measured in Daltons. Molar mass has units of gram per mole . In case of molecules, where molar mass  in grams present in one mole  of atoms is its atomic mass.

Number of moles is calculated as, mass/molar mass, thus on substitution , number of moles=20/12=1.66 moles.

Thus, there are 1.66 moles in 20  grams of carbon.

Learn more about moles,here:

https://brainly.com/question/26416088

#SPJ6

Answer:   m =  4.2 gAgCl

Explanation:  

Answer:

a) Xac = 0.39

b) Xac = 0.58

c) There would be a difference in the two values of the equilibrium conversion because in constant pressure condition it would take longer time to reach the same conversion rate ( higher conversion equilibrium ) and this because the volume increase with the reaction at constant pressure

Explanation:

From elementary gas phase reaction

Cao = Po / RT

Po = 10

R = 82.06

T = 400 K

Cao = 3.05 * 10^-4  mol/cm^3 ≈ 0.305 mol/dm^3

Kc = 0.25 (mol/dm^3 )^2

Calculate the equilibrium conversion for each of the following situations

a) The gas-phase reaction is carried out in a constant-volume batch reactor

Xac = 0.39

b) The gas-phase reaction is carried out in a constant-pressure batch reactor

Xac = 0.58

c) There would be a difference in the two values of the equilibrium conversion because in constant pressure condition it would take longer time to reach the same conversion rate ( higher conversion equilibrium ) and this because the volume increase with the reaction at constant pressure

Attached below is a detailed solution as regards the question above

Answer:

Living in close association

Explanation:

Answer:

9

Explanation:

V=I*R

3*3

Thats the answer

Answer:

depends on what molecule you are looking for

Explanation:

In one mole of stuff (atoms, molecules, eggses), there are NA individual items of that stuff. So, there are 4.5 × NA BCl3 molecules; i.e. 4.5 × 6.022×1023 ≅ 27×1023 individual molecules of BCl3

Answer:

Conduction  

Conduction moves heat through direct sub-atomic crash. A region of more prominent dynamic energy will move nuclear power to a region with lower active energy. Higher-speed particles will crash into more slow speed particles. The more slow speed particles will increment in motor energy subsequently. Conduction is the most widely recognized type of warmth move and happens through actual contact. Models is place your hand against a window or spot metal into an open fire.  

The interaction of warmth conduction relies upon the accompanying components: temperature slope, cross-segment of the material, length of the movement was, and actual material properties. The temperature inclination is the actual amount that portrays the bearing and pace of warmth travel. Temperature stream will consistently happen from most sultry to coldest or, as expressed previously, higher to bring down active energy. Once there's warm harmony between the two temperature contrasts, the warm exchange stops.

Convection  

At the point when a liquid, like air or a fluid, is warmed and afterward ventures from the source, it conveys the nuclear power along. This sort of warmth move is called convection. The liquid over a hot surface grows, turns out to be less thick, and rises.

Radiation

Thermal radiation generates from the emission of electromagnetic waves. These waves carry the energy away from the emitting object. Radiation occurs through a vacuum or any transparent medium (either solid or fluid). Thermal radiation is the direct result of random movements of atoms and molecules in matter. Movement of the charged protons and electrons results in the emission of electromagnetic radiation.

Answer:

True

Explanation:

Answer:

The common sources of outdoor air pollution are emissions caused by combustion processes from motor vehicles, solid fuel burning and industry. Other pollution sources include smoke from bushfires, windblown dust, and biogenic emissions from vegetation (pollen and mold spores).

smog is produced when sunlight reacts with nitrogen oxides in the atmosphere. Nitrogen oxides come from car exhaust, coal power plants, and factory emissions. When sunlight hits these chemicals, they form airborne particles and ground-level ozone—or smog.

Answer:

A-B) 94 %.

C) 17.9 %.

D) 35.8 %.

Explanation:

Hello!

A-B) In this case, since the total mass of the mixture is 3.02 g and 1.43g+1.41g=2.84 g are recovered in total, we can compute the percent recovery as shown below:

[tex]\%rec=\frac{2.84g}{3.02g}*100\%\\\\\%rec=94\%[/tex]

C) Here, since the solution is made up of NaCl and water, we can say that the mass of the solution is 15g+69g=84g; thus, the percent by mass would be:

[tex]\%=\frac{15g}{84g}*100\%\\\\\%=17.9\%[/tex]

D) In this case, we simply divide 26.1 g by 73.0 g in order to obtain the percent:

[tex]\%=\frac{26.1g}{73.0g}*100\%\\\\\%=35.8\%[/tex]

Best regards!

The percentage in the cases are as follows;

Questions A and B are similar and can be solved as follows;

Question C can be solved as follows;

Question D can be solved as follows;

Read more:

https://brainly.com/question/24712879

Answer:

5 × 10⁻³ mol

Explanation:

Step 1: Given data

Step 2: Convert "V" to dm³

We will use the conversion factor 1 dm³ = 1000 cm³.

25 cm³ × 1 dm³/1000 cm³ = 0.025 dm³

Step 3: Calculate the moles of HCl (n)

We will use the definition of molarity.

C = n/V

n = C × V

n = 0.2 mol/dm³ × 0.025 dm³ = 5 × 10⁻³ mol

Answer:

20 atoms

Explanation:

n=3

H =12

p=1

O=4

3+12+1+4=20

Answer:

540.54 mmHg

Explanation:

We know that the partial pressure of a substance is defined as; Mole fraction * total pressure.

If the total amount of gases in the atmosphere is 100%, the mole fraction of nitrogen gas is now

78/100 = 0.78

Thus, partial pressure of nitrogen gas = 0.78 * 693 = 540.54 mmHg

Answer:

Forgive me if im wrong but i am pretty sure the answer is C

Explanation:

Answer:

1) Helium

2) Oxygen

3)Carbon

4) Chlorine

5) Magnesium

Explanation:

Helium has the electron arrangement 2, 2. There are two electrons in the first shell and two electrons in the second shell.

Oxygen is the first member of group 16, there are two energy levels in oxygen which are 2,6.

Carbon is in period 2 and is the first member of group 14 (the silicon family).

Chlorine has 7 valence electrons, the electrons are arranged as 2, 8, 7.

Magnesium has 12 protons and 12 electrons. It is the second member of period 3.

Answer:

platelets?

Explanation:

the question is vauge. but I hope you got it right!

Answer:

Cell division ?

Explanation:

Answer:

Electrons are moved through a magnet, creating a current. That current interacts with a circuit, moving the conductor in the orientation of the field.

Explanation:

Electro magnetic fields are used to create electric current by the movement of electrons. When a coil of wire is wrapped around a magnet it pushes electrons and they flow through a magnet to create current. This current interacts with circuit to move conductor.

Answer:

0.80 seconds (2 significant figures)

Explanation:

The equation of the reaction is given as;

CICH2CH2Cl (g) --> CH2CHCI (g) + HCl(g)

Rate constant (k) = 2.01 s^-1

From the units of the rate constant, this is a first order reaction.

Initial Concentration = 1.34 M

t = ?

Final concentration = 20% of 1.34 = 0.268 M

The integrated rate law for a first order reaction is given as;

ln[A] = ln[A]o - kt

ln(0.268) = ln(1.34) - 2.01(t)

-2.01(t) = - 1.6094

t = 0.8007 ≈ 0.80 seconds (2 significant figures)

Answer:

It bonds with the added H+ or OH in solution.

Explanation:

Answer: yes

Explanation:

Answer:

solid,liquids,gases & plasma